Please wait while the page loads...

2013 Acura MDX Check Engine Light

If the check engine light in your 2013 Acura MDX starts flashing, that means that the problem needs urgent attention and your Acura should be brought in immediately. A flashing light indicates that the problem is precarious and if not taken care of immediately may result in big damage to the vehicle. This blinking light commonly indicates a relentless engine misfire allowing unburned fuel to be discharged into the exhaust system. There it can immediately increase the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can specifically be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If your check engine light is twinkling, please contact our unit of automotive specialists at Crown Acura Greensboro urgently by calling 3368142554. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very lavish repair.

2013 Acura MDX Check Engine Light Flashing

Although there are countless conceivable causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are plentiful decent causes including something as uncomplicated as a loose gas cap. Other decent reasons for a Check Engine Light are damaged oxygen sensor, faulty emissions control part, dirty mass airflow sensor, a malfunction with the fuel injection system, faulty head gasket, or defective spark plugs to name assorted. No matter what is the root cause of the Check Engine Light, we have the Acura Certified Technicians and the certified service protocol to isolate the root problem and repair it as fundamental to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Acura issue was fixed.

Every 2013 Acura MDX was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its important systems. The sensors are continually detecting conditions while sending data to the computerized control company. If the computerized control company detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Crown Acura Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Greatly Qualified Service professional.

Will the check engine light reset itself?

The check engine light on your 2013 Acura MDX will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going correct, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Acura MDX light will go off after about 20-40 miles. If you drive over that fee and the light is still on, you will need to bring it in to Crown Acura Greensboro so the light and code can be double-checked and reset.

Check Engine Light Service 2013 Acura MDX

What do you do when you’re driving along in your Acura MDX and instantly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Acura owners, your heart sinks a small because you have small idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the rate of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Acura MDX checked as soon as conceivable. Ignoring that warning could end up causing leading damage to pricey engine parts.

When your 2013 Acura MDX's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t acceptable, a computer turns on your check engine light. This amber or yellow light is mostly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is learn with an technological scan tool that is used by our Acura auto repair mechanics at Crown Acura Greensboro. There are also a number of relatively cheap code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced expert to indicate the issue and repair it.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is commonly between $88 and $111. The satisfactory news, Crown Acura Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to help illustrate the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not correctly tightened to a more applicable failure like a harmful catalytic converter or a problem with one of the car's oxygen sensors, so it satisfactory to get the appropriate code reading and diagnosis.

2013 Acura MDX Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that miniature light on your vehicle’s dashboard instantly illuminates, but in reality, it is not something that should cause you to shut down in fear honest away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also logical as the OBD (on-board computer diagnostic system) in your MDX. There are hundreds of disparate codes that your check engine light can represent. While that sounds daunting, with a miniature patience, tackling central diagnostics will give you convenient knowledge about your vehicle and will also allow that Check Engine Light to do what it is truly supposed to do: be your guide. Unfortunately, accessible and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of conceivable OBD codes, there are also hundreds of conceivable reasons for the light, including:

  • Transmission issues
  • Emissions controls issues
  • Loose Gas Cap or Missing Gas Cap
  • O2 Sensor
  • Ignition system faults
  • Fuel and air metering systems problems
  • Bad Spark Plugs
  • Computer output circuit issues
  • Old Battery

This is why it is critical for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Crown Acura Greensboro at 3368142554 today or schedule your check engine light service online today! If the engine light comes on due to a critical concern, you risk damaging your car disparate by not repairing the issue honest away. When your check engine light comes on, you should get it checked out abruptly by a certified Acura technician.

How many miles can you drive with the check engine light?

It could be anything from a bad sensor to plug wires needing to be replaced. If you check engine light is flashing, we advise that you pull over and contact Crown Acura Greensboro to help choose if your automobile is safe to drive in or if we advise a tow truck. Since each check engine code has its own level of severity, it is fundamental to predict how bountiful miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy subsequently.

What could cause the check engine light to come on in a 2013 Acura MDX?

When your check engine light comes on, this could be as easy as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a precarious problem that could cause precarious wear and tear to your engine and come with a humongous repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow normally means something less precarious but a flashing check engine light illustrates that your vehicle’s engine is in precarious trouble and service is basic immediately. If your check engine light is flashing in your 2013 Acura MDX, we highly recommend not to drive the vehicle and schedule Acura service today. Below is a list of the most commonplace reasons your check engine light can come on:

  • One of the most accessible and frequent cause is that your 2013 Acura MDX gas cap is loose, damaged or missing. The gas cap for your 2013 Acura MDX serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is departed or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't lavish. If your check engine light turns on hastily after you put gas in your 2013 Acura MDX, initial thing you should check is to make satisfied the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Acura MDX is what determines how much fuel is needed to run your engine efficiently by measuring the reward of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to cognizant changes, like altitude. If your Acura MDX is having trouble starting, idling rough or has a immediate change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your 2013 Acura MDX has a vacuum leak. Every Acura MDX has a vacuum system that performs a extensive assortment of functions. The vacuum system also helps reduce harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can parched out and crack, especially if they’re exposed to exciting heat or extreme frigid.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Acura MDX’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Crown Acura Greensboro offers a complimentary multi-point inspection with every Acura service. If you have an issue with your catalytic converter and don't get it repaired, your 2013 Acura MDX will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause back-up problems from overheating.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, admitted as the O2 sensor, measures the reward of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less definite when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2013 Acura MDX's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to hint the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • The battery is low or dead. The battery in your 2013 Acura MDX is every conclusive. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a little decades ago, and they don't really require maintenance. The price of a new one depends on the type of Acura you drive, but check our simple service coupons and specials.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or back-up item can wreak havoc on your 2013 Acura MDX if it’s not installed properly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound cognizant, bring your MDX to Acura and have our team of certified technicians ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts initial place might cost a scant bit more but could save you money from having to get poor function and damage caused by poor installation function corrected.
  • New Spark Plugs or Plug Wires are needed for your 2013 Acura MDX. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires bring the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or departed, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, finest to more lavish repairs.

What Does the Check Engine Light Mean?

One of the most naturally misunderstood lights or indicators in your 2013 Acura MDX is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few divergent ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2013 Acura MDX. Some of these include controlling engine speed, ignition timing, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can represent a variety of divergent things. It can be as straightforward as your gas cap being loose or as treacherous as engine knocking. If your check engine light is on in your 2013 Acura MDX, contact Crown Acura Greensboro. Our Acura service department can help you choose what code is turning your check engine light on or audit why your check engine light is flashing. Contact Crown Acura Greensboro today!

Is it safe to drive your 2013 Acura MDX with the check engine light on?

If the check engine light is flashing, this means that there is a relentless issue and it is recommended to service your Acura MDX quickly. This question is not very authentic because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to travel to work. This is naturally indicated by a logical glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more relentless problem. Call the veterans at Crown Acura Greensboro by dialing 3368142554 so you can describe the issues. Or lower your speed and bring your 2013 Acura to our certified mechanics as soon as achievable.