Please wait while the page loads...

2013 Acura RDX Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that scant light on your vehicle’s dashboard suddenly flashes, but in reality, it is not something that should cause you to shut down in fear honest away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your RDX. There are hundreds of obvious codes that your check engine light can indicate. While that sounds daunting, with a scant patience, tackling needed diagnostics will give you nice knowledge about your vehicle and will also allow that Check Engine Light to do what it is truly supposed to do: be your guide. Unfortunately, noticeable and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of viable OBD codes, there are also hundreds of viable reasons for the light, including:

  • Computer output circuit issues
  • Ignition system faults
  • Loose Gas Cap or Missing Gas Cap
  • Transmission issues
  • Emissions controls issues
  • Bad Spark Plugs
  • Fuel and air metering systems problems
  • Old Battery
  • O2 Sensor

This is why it is extensive for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a forceful concern, you risk damaging your car further by not repairing the issue correct away. Call Crown Acura Greensboro at 3368142554 expeditiously or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out rapidly by a certified Acura mechanic.

What could cause the check engine light to come on in a 2013 Acura RDX?

When your check engine light comes on, this could be as straightforward as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a harsh problem that could cause harsh damage to your engine and come with a gargantuan repair bill. Depending on your make and model, the check engine light will illuminate or blink. A lucid glow mostly means something less harsh but a flashing check engine light indicates that your vehicle’s engine is in harsh trouble and service is fundamental abruptly. If your check engine light is flashing in your 2013 Acura RDX, we highly recommend not to drive the vehicle and schedule Acura service today. Below is a list of the most contemporary reasons your check engine light can come on:

  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Acura RDX’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Crown Acura Greensboro offers a complimentary multi-point inspection with every Acura service. If you have an issue with your catalytic converter and don't get it fixed, your 2013 Acura RDX will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause back-up problems from overheating.
  • New Spark Plugs or Plug Wires are needed for your 2013 Acura RDX. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or aged, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, large to more costly repairs.
  • Your 2013 Acura RDX has a vacuum leak. Every Acura RDX has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower detrimental emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to imposing heat or extreme freezing.
  • Issues with each aftermarket items. An aftermarket alarm, exhaust or back-up item can wreak havoc on your 2013 Acura RDX if it’s not installed perfectly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the car from starting. If these issues sound commonplace, bring your RDX to Acura and have our team of certified mechanics ensure that your aftermarket items were installed perfectly and aren't causing each issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts initial place might cost a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • The battery is poor or dead. The battery in your 2013 Acura RDX is every efficient. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a bit decades ago, and they don't really require maintenance. The price of a new one depends on the type of Acura you drive, but check our essential service coupons and specials.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Acura RDX is what determines how much fuel is needed to run your engine efficiently by measuring the reward of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to detailed changes, like altitude. If your Acura RDX is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • One of the most essential and frequent cause is that your 2013 Acura RDX gas cap is loose, damaged or missing. The gas cap for your 2013 Acura RDX serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is aged or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't costly. If your check engine light turns on rapidly after you put gas in your 2013 Acura RDX, initial thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the reward of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your car will be less obvious when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2013 Acura RDX's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to indicate the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.

Will the check engine light reset itself?

The check engine light on your 2013 Acura RDX will ordinarily shut itself off if the issue or code that caused it to turn on is revamped. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going practical, and you did a few of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Acura RDX light will go off after about 20-40 miles. If you drive over that fee and the light is still on, you will need to bring it in to Crown Acura Greensboro so the light and code can be double-checked and reset.

What Does the Check Engine Light Mean?

One of the most typically misunderstood lights or indicators in your 2013 Acura RDX is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few odd ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your car. Onboard computers increasingly have controlled and monitored car performance since the 80s and do a variety of things for your 2013 Acura RDX. Some of these include shifting automatic transmissions controlling engine speed, ignition timing, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of different things. It can be as evident as your gas cap being loose or as compelling as engine knocking. If your check engine light is on in your 2013 Acura RDX, contact Crown Acura Greensboro. Our Acura service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Crown Acura Greensboro today!

2013 Acura RDX Check Engine Light Flashing

Although there are bountiful ability causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several pure causes including something as easy as a loose gas cap. Distinct pure reasons for a Check Engine Light are dirty mass airflow sensor, damaged oxygen sensor, a malfunction with the fuel injection system, faulty emissions control part, faulty head gasket, or defective spark plugs to name some. No matter what is the root cause of the Check Engine Light, we have the Acura Certified Mechanics and the certified service protocol to isolate the root problem and repair it as mandatory to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Acura issue was fixed.

Every 2013 Acura RDX was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its critical systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what explicitly is awry nor what to do about it. That’s where we come in; Crown Acura Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Exceedingly Qualified Service experienced.

Check Engine Light Service 2013 Acura RDX

What do you do when you’re driving along in your Acura RDX and quickly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Acura owners, your heart sinks a microscopic because you have microscopic idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the estimate of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Acura RDX checked as soon as helpful. Ignoring that warning could end up causing principal damage to costly engine components.

When your 2013 Acura RDX's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electrical control system that it can’t appropriate, a computer turns on your check engine light. This amber or yellow light is naturally labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electrical scan tool that is used by our Acura auto repair mechanics at Crown Acura Greensboro. There are also a number of relatively economical code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an trained professional to determine the issue and repair it.

Is it safe to drive your 2013 Acura RDX with the check engine light on?

If the check engine light is twinkling, this means that there is a perilous issue and it is recommended to service your Acura RDX quickly. This question is not very straightforward because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is typically indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more risky problem. Call the specialists at Crown Acura Greensboro by dialing 3368142554 so you can describe the issues. Or reduce your speed and bring your 2013 Acura to our certified mechanics as soon as available.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we advocate that you pull over and contact Crown Acura Greensboro to help determine if your car is safe to travel to work in or if we advocate a tow truck. It could be anything from a harmful sensor to plug wires needing to be replaced. The safest bet is to decipher the code and then plan your strategy accordingly. Since every check engine code has its own level of severity, it is hard to predict how many miles you can travel to work with the warning light on.

2013 Acura RDX Check Engine Light

If the check engine light in your 2013 Acura RDX starts flashing, that means that the problem needs abrupt attention and your Acura should be brought in instantly. A flashing light suggests that the problem is persuasive and if not taken care of instantly may result in major damage to the vehicle. This glaring light usually indicates a strict engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can rapidly raise the temperature of the catalytic converter to a point where damage is likely, requiring an lavish repair. Some owners ask if spark plugs cause the check engine light to flash? This can certainly be the cause. A bad, aged or dirty spark plug can cause the engine to misfire. If your check engine light is flashing, please contact our team of automotive experts at Crown Acura Greensboro rapidly by calling 3368142554. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very fancy repair.

How much does it cost to get the engine light checked?

The intermediate price for a check engine light diagnosis & testing is typically between $88 and $111. The favorable news, Crown Acura Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to help pick the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not accurately tightened to a more relentless failure like a harmful catalytic converter or a problem with one of the car's oxygen sensors, so it favorable to get the persuasive code reading and diagnosis.