Please wait while the page loads...

2018 Acura MDX Check Engine Light

If the check engine light in your 2018 Acura MDX starts flashing, that means that the problem needs abrupt attention and your Acura should be brought in immediately. A flashing light indicates that the problem is hazardous and if not taken care of immediately may result in major damage to the vehicle. This blinking light commonly indicates a harsh engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can promptly increase the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. A Miniature owners ask if spark plugs cause the check engine light to flash? This can solely be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our team of automotive mentors at Crown Acura Greensboro expeditiously by calling 3368142554.

How many miles can you drive with the check engine light?

Since each check engine code has its own level of severity, it is bizarre to predict how many miles you can drive with the warning light on. It could be anything from a bad sensor to plug wires needing to be replaced. The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is flashing, we recommend that you pull over and contact Crown Acura Greensboro to help determine if your vehicle is dependable to drive in or if we recommend a tow truck.

2018 Acura MDX Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that miniature light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear reasonable away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your MDX. There are hundreds of disparate codes that your check engine light can represent. While that sounds daunting, with a miniature patience, tackling meaningful diagnostics will give you accessible knowledge about your vehicle and will also allow that Check Engine Light to do what it is surely supposed to do: be your guide. Unfortunately, accessible and favorable vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of viable OBD codes, there are also hundreds of viable reasons for the light, including:

  • O2 Sensor
  • Ignition system faults
  • Old Battery
  • Fuel and air metering systems problems
  • Bad Spark Plugs
  • Loose Gas Cap or Missing Gas Cap
  • Computer output circuit issues
  • Emissions controls issues
  • Transmission issues

This is why it is basic for someone who does not have various of automotive knowledge to not assume what a code means. Call Crown Acura Greensboro at 3368142554 today or schedule your check engine light service online today! If the engine light comes on due to a distinguished concern, you risk damaging your car further by not repairing the issue honest away. When your check engine light comes on, you should get it checked out promptly by a certified Acura mechanic.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2018 Acura MDX is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a lot divergent ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2018 Acura MDX. Some of these include ignition timing, controlling engine speed, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of authentic things. It can be as important as your gas cap being loose or as exacting as engine knocking. If your check engine light is on in your 2018 Acura MDX, contact Crown Acura Greensboro. Our Acura service department can help you find out what code is turning your check engine light on or audit why your check engine light is flashing. Contact Crown Acura Greensboro today!

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not perfectly tightened to a more relentless failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it contractual to get the handy code reading and diagnosis. The average rate for a check engine light diagnosis & testing is frequently between $88 and $111. The contractual news, Crown Acura Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to aid designate the cause of your check engine light.

Is it safe to drive your 2018 Acura MDX with the check engine light on?

This question is not very pure because it each depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be able to drive. This is continually indicated by a consistent glow of the check engine light. If you notice a difference in the performance of the car, it could be an indication of a more threatening problem. If the check engine light is blinking, this means that there is a threatening issue and it is recommended to service your Acura MDX abruptly. Call the consultants at Crown Acura Greensboro by dialing 3368142554 so you can describe the issues. Or reduce your speed and bring your 2018 Acura to our certified mechanics as soon as accessible.

2018 Acura MDX Check Engine Light Flashing

Although there are many ability causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are assorted common causes including something as uncomplicated as a loose gas cap. Contrasting common reasons for a Check Engine Light are a malfunction with the fuel injection system, dirty mass airflow sensor, faulty head gasket, damaged oxygen sensor, faulty emissions control part, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Acura Certified Technicians and the certified service protocol to isolate the root problem and repair it as mandatory to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Acura issue was fixed.

Every 2018 Acura MDX was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its troublesome systems. The sensors are commonly detecting conditions while sending data to the electronic control squad. If the electronic control squad detects that the data is out of factory specifications, the Check Engine Light flashes telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is amiss nor what to do about it. That’s where we come in; Crown Acura Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service professional.

What could cause the check engine light to come on in a 2018 Acura MDX?

When your check engine light comes on, this could be as authentic as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a dangerous problem that could cause dangerous damage to your engine and come with a great repair bill. Depending on your make and model, the check engine light will illuminate or blink. A consistent glow continuously means something less dangerous but a flashing check engine light indicates that your vehicle’s engine is in dangerous trouble and service is needed abruptly. If your check engine light is flashing in your 2018 Acura MDX, we exceptionally advocate not to drive the vehicle and schedule Acura service today. Below is a list of the most authentic reasons your check engine light can come on:

  • New Spark Plugs or Plug Wires are mandatory for your 2018 Acura MDX. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, extensive to more expensive repairs.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2018 Acura MDX’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is frequently caused by neglected maintenance, which is why Crown Acura Greensboro offers a complimentary multi-point inspection with all Acura service. If you have an issue with your catalytic converter and don't get it serviced, your 2018 Acura MDX will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause added problems from overheating.
  • The battery is low or dead. The battery in your 2018 Acura MDX is all necessary. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The price of a new one depends on the type of Acura you drive, but check our current service coupons and specials.
  • Your 2018 Acura MDX has a vacuum leak. All Acura MDX has a vacuum system that performs a roomy variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, exceptionally if they’re exposed to remarkable heat or extreme cold.
  • One of the most accepted and frequent cause is that your 2018 Acura MDX gas cap is loose, damaged or missing. The gas cap for your 2018 Acura MDX serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on instantly after you put gas in your 2018 Acura MDX, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your O2 Sensor (Oxygen Sensor) needs to be changed. The Oxygen sensor, accepted as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be fewer definite when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2018 Acura MDX's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to read the honest mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or added item can wreak havoc on your 2018 Acura MDX if it’s not installed accurately. These aftermarket parts and accessories can jettison the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound accepted, bring your MDX to Acura and have our team of certified mechanics ensure that your aftermarket items were installed perfectly and aren't causing any issue. Getting accessories, exceptionally aftermarket parts and accessories, or using OEM parts first place might cost a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • Your mass airflow sensor (known as MAF) needs to be changed. The mass airflow sensor in your Acura MDX is what determines how much fuel is mandatory to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to current changes, like altitude. If your Acura MDX is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.

Check Engine Light Service 2018 Acura MDX

What do you do when you’re driving along in your Acura MDX and shortly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Acura owners, your heart sinks a microscopic because you have microscopic idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the price of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2018 Acura MDX checked as soon as attainable. Ignoring that warning could end up causing dominant wear and tear to pricey engine components.

When your 2018 Acura MDX's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t apt, a computer turns on your check engine light. This amber or yellow light is constantly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is find out with an electrical scan tool that is used by our Acura auto repair mechanics at Crown Acura Greensboro. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you favor that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced trained to determine the issue and repair it.

Will the check engine light reset itself?

The check engine light on your 2018 Acura MDX will usually shut itself off if the issue or code that caused it to turn on is serviced. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did many of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2018 Acura MDX light will go off after about 20-40 miles. If you drive over that payment and the light is still on, you will need to bring it in to Crown Acura Greensboro so the light and code can be double-checked and reset.